GB/T 30816-2014 工程用生物基復合材料術語

本標準規定了工程用生物基復合材料的常用術語和定義。本標準適用于工程用生物基復合材料及其相關領域的標準化文件和技術文件,其他領域參照使用本標準應研究其適用性。

Terminology for bio-based composite materials in engineering

GB/T 2433-2001 添加劑和含添加劑潤滑油硫酸鹽灰分測定法

1.1本標準規定了測定未經使用的含添加劑的潤滑油和用于調和潤滑油的添加劑濃縮物中硫酸鹽灰分質量分?jǐn)?shù)的方法。這些添加劑通常含有一種或多種金屬：鋇、鈣、鎂、鋅、鉀、鈉和錫元素。而元素硫、磷和氯則以結合形式存在。 1.2本標準測定的硫酸鹽灰分的質量分?jǐn)?shù)下限為0.005%。當硫酸鹽灰分小于0.02%時，本標準僅適用于只含有無灰添加劑潤滑油。 1.3本標準不適用于測定用過的含鉛添加劑的發動機油，也不適用于不含添加劑潤滑油，對于這些油品可以采用GB/T508。 1.4硫酸鹽灰分可以用來表明新潤滑油中已知的含金屬添加劑的濃度。當不含磷時，鋇、鈣、鎂、鈉、鉀轉變?yōu)榱蛩猁}，錫（IV）和鋅轉變?yōu)樗鼈兊难趸铮ㄒ娮ⅲ?，硫和氯并無干擾。但是當磷與金屬添加劑同時存在時，它以金屬磷酸鹽的形式部分或全部保留在硫酸鹽灰分中。 1.5本標準涉及某些危險材料、操作和設備。但無意對與此有關的所有安全問題都提出建議。因此，用戶在使用本標準之前應建立適當?shù)陌踩头雷o(hù)措施并確定有適用性的管理制度。

Petroleum products-Lubricating oils and additives-Determination of sulphated ash

DB43/T 2528-2022 柴油清凈增效劑技術要求

Technical Requirements for Diesel Detergent and Booster

SY/T 7328-2021 驅油用石油磺酸鹽

Petroleum sulfonates for oil displacement

NB/SH/T 0982-2019 潤滑油金屬清凈劑濁度測定法

Turbidity determination method for lubricating oil metal detergents

SY/T 7328-2016 驅油用石油磺酸鹽

Petroleum sulfonates for oil displacement

SY/T 5888-2016 浮選劑浮選效果評價方法 葉輪浮選法

Flotation agent flotation effect evaluation method Impeller flotation method

DL/T 449-2015 油浸纖維質絕緣材料含水量測定法

本標準規定了油浸纖維質絕緣材料含水量的測試方法。 本標準適用于新的和老化的干紙及油浸紙、油浸紙板和白布帶中水分含量的測定。 本標準適用于測定含水量為0.1%~20%的樣品。

Determination of water in oil-impregnated fibrous insulation material

CAS 107-2006 燃油清凈助燃劑

本標準規定了以硝基化合物為主劑，加入助溶劑、清凈劑等組份復配而成的燃油清凈助燃劑的分類、要求、試驗方法、檢驗規則、標志、包裝、運輸及貯存。 本標準適用于添加到車用汽油或柴油中的燃油清凈助燃劑。添加了本產品的燃油具有清凈、助燃、節能、環保等功能。

Deposit Combustion Control Fuel Additive

CAS 109-2004 點燃式發動機檢測用油

本標準規定了點燃式發動機檢測用油的牌號，產品分類，技術要求，抽樣規則及標志、包裝、運輸及貯存等。 本標準適用于由液體烴類調配而成，并加有適量抗氧防膠劑和汽油清凈劑以及檢測用油專用助劑的點燃式發動機檢測用油。 符合本標準的產品適用于點燃式發動機及整車功率、油耗、廢氣排放、產品質量控制、相應油品檢測儀器、設備等的鑒定、驗收、檢測、校準、評定、認證、審驗及仲裁試驗。

Reference Fuel Specification for Ignition Engine Performance Test

CAS 108-2004 壓燃式發動機檢測用油

本標準規定了壓燃式發動機檢測用油的產品分類，技術要求，抽樣規則及標志、包裝、運輸及貯存等。 本標準適用于壓燃式發動機檢測用油。 符合本標準的產品適用于壓燃式發動機及整車功率、油耗、廢氣排放、產品質量控制、相應油品檢測儀器、設備等的鑒定、驗收、檢測、校準、評定、認證、審驗及仲裁試驗。

Reference Fuel Specification for Diesel Engine Performance Test

CAS 106-2004 車用汽油及清凈劑清凈性限值(模擬法)

本標準規定了車用汽油及清凈劑，按汽油機進氣閥沉積物模擬試驗方法檢驗的清凈性限值。 本標準適用于車用汽油及清凈劑的清凈性檢測。

Detergency Effect For Automobile Gasoline/Fuel Detergents(Simulation Technique)

ASTM D322-97(2007) 蒸餾法測定汽油發動機廢機油中汽油稀釋劑的試驗方法

Some fuel dilution of the engine oil may take place during normal operation. However, excessive fuel dilution is of concern in terms of possible performance problems.1.1 This test method covers determination of the amount of dilution in crankcase oils of engines when gasoline has been used as the fuel.Note 1There may be cases in dispute, therefore, the user of this test method is advised to establish whether this method will be accepted. There may be cases where Test Method D 3525 results will be set as the referee value.1.2 The values stated in acceptable SI units are to be regarded as the standard.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statement, see 6.4, 7.1, and 9.3.

Standard Test Method for Gasoline Diluent in Used Gasoline Engine Oils by Distillation

ASTM D322-97 蒸餾法測定汽油發動機廢機油中汽油稀釋劑的試驗方法

1.1 This test method covers determination of the amount of dilution in crankcase oils of engines when gasoline has been used as the fuel. 1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statement, see 5.4. 1.3 The values stated in acceptable SI units are to be regarded as the standard.

Standard Test Method for Gasoline Diluent in Used Gasoline Engine Oils by Distillation

SH/T 0309-1992 含添加劑潤滑油的鈣、鋇、鋅含量測定法（絡合滴定法）

Determination method of calcium, barium and zinc content in lubricating oil containing additives (complexometric titration method)

SH/T 0389-1992 石油添加劑的分類

Classification of Petroleum Additives

SH/T 0034-1990 添加劑中有效組分測定法

Determination of effective components in additives

SH/T 0027-1990 添加劑中鎂含量測定法（原子吸收光譜法）

Determination of magnesium content in additives (atomic absorption spectrometry)

BS 5117 Sec.1.4:1985 發動機濃縮冷卻劑("抗凍劑")的腐蝕抑制試驗.第1部分:測定物理和化學特性的試驗方法.第1.4節:發泡特性測定

Testing corrosion inhibiting, engine coolant concentrate ('antifreeze'). Methods of test for determination of physical and chemical properties. Determination of foaming characteristics

BS 5117 Sec.1.3:1985 發動機濃縮冷卻劑("抗凍劑")的腐蝕抑制試驗.第1部分:測定物理和化學特性的試驗方法.第1.3節:凍結點測定

Testing corrosion inhibiting, engine coolant concentrate ('antifreeze'). Methods of test for determination of physical and chemical properties. Determination of freezing point