共找到 150 條與 探測尺寸誤差 相關的標準，共 10 頁
Настоящий стандарт распространяется на допуски и посадки деталей при размерах от 0,1 до 1
Tolerances and fits in dimensions less than 1 mm
Tolerances in mechanical engineering - Tolerances for sizes without tolerance indication - Deviations for sizes of sizes of wrought copper and copper alloys forgings
Permissiable deviation without tolerance indication for press working of sheet metal
B-l Esta norma establece un Sistema, de Tolerancias y Discrepancias, de piezas en general, para grupos de diámetros basta 500 mm. B-2
Basic tolerance and deviation size 500mm is sufficient
Tolerances for linear sizes. Terminology
Castings; System of dimensional tolerances
Versione in lingua italiana della norma europea EN 390 (edizione novembre 1994). Specifica gli scostamenti ammissibili rispetto alle dimensioni del
Glued laminated timber. Sizes. Permissible deviation.
ADOPTED_FROM:ISO 8062:1984
Castings — System of dimensional tolerances
Candélabres d'éclairage public - Partie 2 : dimensions et tolérances et dimensions
This International standard specifies dimensions and tolerances to the dimensions applicable to steel wire rod as defined in ISO 6929
Steel wire rod - Dimensions and tolerances
本標準所規定的標注印制板尺寸和公差的規則、原理和方法適用于布設總圖對成品印制板的要求
Printed board dimensions and tolerances
本標準規定了常用扳手的板手口尺寸與公差。 本標準適用于呆扳手、梅花扳手、套筒扳手、內六角扳手等常用扳手
Wrench Size and Tolerance
Textiles floor coverings. Dimensional tolerances.
La présente norme spécifie les caractéristiques dimensionnelles des clavettes disques
Disk-shaped keys. Dimensions and tolerances
Prezentul standard se refer? la abaterile limit? admise la dimensiunile garniturilor din cauciuc compacte ob?inute prin presare ?n matri?e sau
RUBBER GASKETS Tolerances for dimensions
